ST-LINK/V2 Debugger and Programmer USB

The ST-Link V2 debugger and programmer is designed for STM8 and STM32 and is manufactured with PCB installed inside of aluminum alloy U disk shell. This factory firmware has been upgraded to support the full-range STM32 SWD and a full-range STM8 SWIM.

This ST-Link programmer is equipped with a 500MA internal resettable fuse that provides complete protection for your expensive computer motherboard. This programmer has a programming speed rate of 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed. It has a red and blue LED indicator that allows users to observe the working condition of the Programmer.

The ST-Link device can be used to send program code to the 32-bit STM32 ARM Cortex or 8-bit STM8 microcontrollers. It contains connections for 5V, 3.3V, SWCLK, SWDIO, SWIM, Reset (RST/NRST), and GND. With the help of the USB connector, it can connected to a computer.

Note: This ST-Link Programmer will not get detected in the STM32CubeIDE as they are clones.

Clickhere to download the Drivers.