MCP2515 Can Bus Module Board

Controlled Area Network of simple CAN is a bus standard that allows a Microcontroller and its peripheral devices to communicate without the need of a host device or a computer.The MCP2515 CAN bus module is designed with anSPI 51 Single Chip Program and features aTJA1050 Receiver. It is created to control a CANBus device by SPI interface with your MCU. It is best used by microcontrollers and boards compatible with Arduino like UNO boards.

The MCP2515 CAN Bus Controller is a simple Module that supports CAN Protocol version 2.0B and can be used for communication at 1Mbps. In order to set up a complete communication system, you will need two CAN Bus modules.

TheMCP2515 CAN bus module consists of standard frames,extended frames, and remote frames. You can use the serial port of theMCP2515 CAN bus module to view communication data as well.

Pin Details

• VCC :5V power input pin
• GND : power ground pin
• CS : SPI SLAVE select pin (Active low)
• SO : SPI master input slave output lead
• SI : SPI master output slave input lead
• SCLK: SPI clock pin
• INT: MCP2515 interrupt pin

Pin Diagram:

Pin Diagram ofMCP2515 Can Bus Module Board

Applications:

• Electronic Gear Shift System
• Automobiles
• Main Interface in Automation (like industrial)
• Medical Equipment
• Robotics
• Auto Start/Stop of Car Engine